Skip to content
The New Filaments Inventory back into the EU and USA warhouse now. We will arrange the shipment according to the according to the order payment order.
The New Filaments Inventory back into the EU and USA warhouse now. We will arrange the shipment according to the according to the order payment order.
SUNLU Fila Dryer S1 Diy Fan Kit | SunLu 3D

SUNLU Fila Dryer S1 Diy Fan Kit

      Adding a fan to the Sunlu FilaDryer S1 makes a big difference in the performance of the dryer. Without it the filament does not achieve an overall temperature. When I set the temperature to 50C the center of the spool barely reached 35C even after 6 hours. With the fan, the center of the filament spool was up to 45C in a little over an hour and up to 50C within 2 hours of starting. It then maintain a good even 50C for the rest of the drying time. This bracket will hold a standard 40x20mm fan. It doesn't require much air flow so get a very slow fan or one with a speed control.

 

Repost by @MidLifeHiker from Thingiverse

STL: https://www.thingiverse.com/thing:4628798?fbclid=IwAR0WRhepzRGSmnv9XpFCY7e8N6TH0PezzJ8mdsZ-g1kxJR9srX543_mM4LY

Next article Does it work? Absolutely!The Most Cost-effective 3D Filament Dryer; Drying filament during printing