Skip to content
Black Friday Sale. All product can use the 10%off discount code: SUNLU10off
Black Friday Sale. All product can use the 10%off discount code: SUNLU10off
SUNLU Fila Dryer S1 Diy Fan Kit | SunLu 3D

SUNLU Fila Dryer S1 Diy Fan Kit

      Adding a fan to the Sunlu FilaDryer S1 makes a big difference in the performance of the dryer. Without it the filament does not achieve an overall temperature. When I set the temperature to 50C the center of the spool barely reached 35C even after 6 hours. With the fan, the center of the filament spool was up to 45C in a little over an hour and up to 50C within 2 hours of starting. It then maintain a good even 50C for the rest of the drying time. This bracket will hold a standard 40x20mm fan. It doesn't require much air flow so get a very slow fan or one with a speed control.

 

Repost by @MidLifeHiker from Thingiverse

STL: https://www.thingiverse.com/thing:4628798?fbclid=IwAR0WRhepzRGSmnv9XpFCY7e8N6TH0PezzJ8mdsZ-g1kxJR9srX543_mM4LY

Next article Does it work? Absolutely!The Most Cost-effective 3D Filament Dryer; Drying filament during printing