#3DPrintingsunluMAKEROADMakerKitRC Car

My print and partial assembly of "MAKEROAD F1"

Hi. Some photos of my printout and partial assembly (awaiting a "MakerKit RC Car") of the model

MAKEROAD F1 (Model ID：M1000185681) https://www.makeroad.com/printable_3D_model/M1000185681

Printer: Elegoo Centauri Carbon 2 Combo, (Ender-3 V3 for the TPU 95A White parts)

Total printing time approximately 25 hours, 51 minutes.

Filaments used: PLA Matte Dual-Color Red Blue MakeRoad/Sunlu, PLA Silk White, PLA Yellow, PLA Silk Red, PLA Recycled (~=Black), PETG Black, TPU 95A White.


Note that the TPU parts were initially printed in transparent TPU 95A on an Elegoo Centauri Carbon 2 Combo, but these had delamination defects and as printing in TPU on the ECC2 requires disconnecting the CANVAS and disassembling the 4-1 hub at the print head inlet, I then preferred to use a Creality Ender-3 V3 with white TPU 95A to reprint these parts.


Good continuation to all.

My print and partial assembly of "MAKEROAD F1" - image 1My print and partial assembly of "MAKEROAD F1" - image 2My print and partial assembly of "MAKEROAD F1" - image 3My print and partial assembly of "MAKEROAD F1" - image 4My print and partial assembly of "MAKEROAD F1" - image 5My print and partial assembly of "MAKEROAD F1" - image 6My print and partial assembly of "MAKEROAD F1" - image 7
2026/6/20 08:22
114