My first assembly of the "MAKEROAD F1" (awaiting a MakeRoad "MakerKit RC Car")

Hi.

A first test assembly without the "MakerKit RC Car" of the model "MAKEROAD F1" https://www.makeroad.com/printable_3D_model/M1000185681 that I recently printed.

Since I don't have the "MakerKit RC Car" yet (shipments normally start in August 2026), I had to improvise to make a first assembly and hold everything in place (paper clips, bits of toothpicks, tape, and double-sided tape to play the role of some screws).

I still have some minor adjustments (deburring, etc.) to make before gluing what should normally be glued.

This topic complements my previous topic: https://www.sunlu.com/community/posts/285/my-print-and-partial-assembly-of-makeroad-f1

where you can see the printed elements side by side.

Good continuation to all.