Questions about "SUNLU PLA Wood"

Hi,

I was lucky enough to win a 1 kg spool of "MAKEROAD PLA Wood" during a MakeRoad event.

This spool is probably a repackaged "SUNLU PLA Wood" spool.

I'm trying to find out about "SUNLU PLA Wood"

- If a nozzle with a diameter of at least 0.6 mm is required to guarantee printing with this Wood filament without the risk of nozzle clogging, or if a 0.4 mm diameter nozzle is sufficient.

(Because for PLA filaments containing particles of material other than PLA, it is often recommended to use a 0.6 mm diameter nozzle and to avoid 0.2 or 0.4 mm diameter nozzles to prevent nozzle clogging due to the particles added to the PLA.)

- If you have experimented with this filament by varying the printing temperature to achieve different shades.

(typically, with wood filament, the higher the temperature, the darker the shade becomes because the wood particles are heated more intensely.)

If you have already tested this filament, please share your opinion and tips.

Thanks in advance and good continuation to all.